On the 6002 kit CVD's there is a spacer #9608 to go between roll pin and rear hub.
Could this be because rear hub #7364 is narrower than the old #6366 hub? (Do I need the spacer when using old hub with appropriate flanged bearings)
//Erik
I need clarification regarding 6002 CVD's
-
teman
- Approved Member
- Posts: 894
- Joined: Sun May 01, 2011 5:57 pm
- Location: Upstate NY
- Been thanked: 6 times
Re: I need clarification regarding 6002 CVD's
I thought it was because it's a B4 axle being used on there which is longer.
-Kevin
Create an account or sign in to join the discussion
You need to be a member in order to post a reply
Create an account
Not a member? register to join our community
Members can start their own topics & subscribe to topics
It’s free and only takes a minute
Sign in
-
- Similar Topics
- Replies
- Views
- Last post
-
- 1381 Replies
- 131084 Views
-
Last post by Smokes
-
- 30 Replies
- 4016 Views
-
Last post by Synergy
-
- 2 Replies
- 462 Views
-
Last post by howsyouraspen
-
- 2 Replies
- 1052 Views
-
Last post by RC104ever
-
- 9 Replies
- 782 Views
-
Last post by cmain
-
- 9 Replies
- 1365 Views
-
Last post by Rayzerp
-
- 3 Replies
- 1092 Views
-
Last post by broodenburg
-
- 1 Replies
- 540 Views
-
Last post by carloco8
Who is online
Users browsing this forum: No registered users and 7 guests