RC10Talk - The Net's Largest Vintage R/C Community

Anyone have any info on the XXT CR? Manual? Differences between the XXT and the XXT CR? Any help would be appreciated. Thanks in advance.

jay

Not to answer my own thread, it is more of a question, but Losi used to have all the older kit manuals on their site. Since the change/update to the site, I can't find them. If anyone can, I would appreciate it. Thanks again.

The CR had shorter arms, a wider pivot block (which was now a seperate piece from the pivot plate) and different hubs. The Graphite Plus was the CR with all the hop-up parts, plus the dual-disk slipper instead of the Hydra-Drive.

quoted from another forum, post by Aaron Waldron

relating to the buggy: *should have read J's question properly*

The CR also had a different shell (I did know the name). two hole front hub carriers, solid battery strap rather than velcro, spoked wheels, different front shock tower (although that may have been the kinwald) and some other detail changes.

turned my XX into a CR and did have a both parts sheets once..

So does that mean that the XX-CR and XXT-CR where esstentially the same thing with a differences in the body, wheels/tires, arms and towers?

Still hoping for a link to Losi's old manuals.

I only could do with the setup sheet. http://losi.com/RaceCenter/DiscontinuedSetups.aspx#doubleXTCR

Did you try the Horizon Hobby homepge?

Yeah, I found the setup sheet. Thanks, I will try horizon.

Here's what I know:
the cr had:
A different body,
Graphite arms, shock towers, and chassis compared to plastic,
Removable rear pivot block,
Rear arms have a separate molded riser that raises the bottom shock mount location,
Hydra drive equipped.

http://www.rcchopshop.com/losi/losiinfo.html

they have the parts lists.....

BINGO! This is all I needed: http://www.rcchopshop.com/pdfs/losi/xxtgraph.pdf

Thank you sir!

bngiles wrote:Here's what I know:
the cr had:
A different body,
Graphite arms, shock towers, and chassis compared to plastic,
Removable rear pivot block,
Rear arms have a separate molded riser that raises the bottom shock mount location,
Hydra drive equipped.

http://www.rcchopshop.com/losi/losiinfo.html

they have the parts lists.....

Did the XXT-CR have graphite or was that the XXT-CR G+? (I have a decal sheet for that truck NIP if anyone is after one)

Which decal set Tom? I would be interested. Let me know. Thank you sir.

There was a graphite plus version of the truck...I believe the decals said "Graphite Plus"

Indeed those are them.. all neon and nineties-like. I'll take a picture and send it for you Jay. Drop me your email again by PM