RC10Talk - The Net's Largest Vintage R/C Community

So it looks like there is a bit of flashing material on the side of my B4.1 worlds chassis, up around the front which I think is causing the A arms to bind a little as well as it is a little sharp in the spots where present.

I figure the A arms will wear down eventually but wondering if I should just ignore it or remove it? and if it is remove it what you guys recommend to do the removing.

Thanks

I shaved and sanded mine smooth!

B4.1 will be sloppy soon enough anyway

J/k - sand it. I'd rather have a bind-free car bon the first pack even if it wears sooner than a car that handles like crap for 10 packs before it starts breaking in

Paul

Hey thanks all, I shaved it down with an xacto and then sanded it, I also switched the rear screws for cap style instead of button...here is the progress so far: