RC10Talk - The Net's Largest Vintage R/C Community

Hello, anybody knows where I can buy an epoxy glass sheet to cut custom shock towers ?
Thanks a lot.

Look in the phone book under plastic/polycarbonate suppliers. I've got two that I know of in my area, one specializes in plexiglass (not what you're looking for ), the other specializes in resin/epoxy sheet goods.

you can buy carbon fiber sheets on ebay

if you want the "greenish" stuff, you want to look for FRP G10.

Yes it's the greenish stuff I'm looking for. I like to make my home parts, like this shock tower (right).



But plastic suppliers only sold big sheets (50x40 inch), I'm looking for a "hobby sized" sheet (12x10 inch 1/8 thick for example).

Thanks .

The local supplier I mentioned had a "scrap" room that had cuts of all sizes of everything they carried. You might check around a little more, one shop in your area may have the same thing.

Does any one know where I can get this plastic in england.If I could find some I could make a new chassis for my CAT XLS.

Moggie XL wrote:Does any one know where I can get this plastic in england.If I could find some I could make a new chassis for my CAT XLS.

Hahaha good luck, if you find some let me know, I couldn't find anything in non-industrial quantities (they also declined to look in there scrap rooms).

ra272 wrote:Hello, anybody knows where I can buy an epoxy glass sheet to cut custom shock towers ?
Thanks a lot.

look here http://www.conrad.com