RC10Talk - The Net's Largest Vintage R/C Community

It's easy, just leave a sticker on a tub for 27 years

RC10resto wrote:It's easy, just leave a sticker on a tub for 27 years

Done! Ok everybody, I'll update you in 2039.

Electronics installed

nice.

this car is making me want to get the last couple pieces i need for my "curtis replica" build.

What are you looking for

RC10resto wrote:Electronics installed

You know, when you make something look so good, and period correct and make it look so easy..... You need to build more

RC10resto wrote:What are you looking for

i don't remember. i haven't touched it in so long. still sitting like this.

scr8p wrote:

RC10resto wrote:What are you looking for

i don't remember. i haven't touched it in so long. still sitting like this.

005.JPG

More ball ends?

pretty sure i have enough ball cups. not to detour brian's thread, but.....

2 left side bellcranks to make an edinger setup
2 mm screws and brass nuts for front wheels
rear sway bar
dubro ball cups for front sway bar
goodyear rears

actually, a complete rc10 sway bar kit would give me everything i need. i could use the ball cups on the front, and the bar and ball studs on the rear. in the pic of curtis's orginal car. the bar is there but it's not hooked up.

then it's just a matter of painting up the body and wing (which i have), and installing what i think would be the correct electronics.

before and after

Body?

I'm telling you, you need to build more

This might be the body, just needs a few stickers and a wing.

That works.

Very nice sir, is that one of the early Associated pre-painted shells?

I think so, I know I didn't paint it