RC10Talk - The Net's Largest Vintage R/C Community

Marui Samurai Help

Hi guys, need your help regarding front dog bones of Marui Samurai.
Could someone post a link on where can I buy a front dog bones of Marui Samurai or any brand with the same size of the said car?

Secondly, do you have an idea on whats is the size of the said front dog bones from pin to pin

thanks

You'll have more luck in your searches with correct spelling of "Marui".

Coelacanth wrote:You'll have more luck in your searches with correct spelling of "Marui".

I stand corrected, thank you
now i got the spelling right, maybe can somebody help ne now

I have some loose dogbones. I'll try to dig one out and get a measurement for you.

RedScampi wrote:I have some loose dogbones. I'll try to dig one out and get a measurement for you.

Thanks hope you find it, I've asked this question many times, but no one can give an answer

I heard that Redcat 02003 will fit. I believe it's a 55mm dog bone.

2nd post here: http://www.rc10talk.com/viewtopic.php?f=33&t=12696
I think they are 61mm per Redcat but can't remember if that's end-to-end or pin-to-pin. Seems that manufacturers use different standards as far as 'length'. BTW I had bought some of the Redcat ones and they are a nice match to the stock 'bones. Good luck.

civilguy wrote:2nd post here: http://www.rc10talk.com/viewtopic.php?f=33&t=12696
I think they are 61mm per Redcat but can't remember if that's end-to-end or pin-to-pin. Seems that manufacturers use different standards as far as 'length'. BTW I had bought some of the Redcat ones and they are a nice match to the stock 'bones. Good luck.

If that's pin-to-pin, maybe some Kyosho 'bones might work. I know they come in 60.5 and 62.5 mm lengths.

I'm pretty sure 61mm was total length and the ball size was different too. I did look for a long time to find a match-- they are short & I think the Redcat parts are actually for 1/16th buggies.
I sold my Samurai to a member here (with the Redcat bones), but apparently once you get to a certain age the details of past transactions begin to elude you.

civilguy wrote:2nd post here: http://www.rc10talk.com/viewtopic.php?f=33&t=12696
I think they are 61mm per Redcat but can't remember if that's end-to-end or pin-to-pin. Seems that manufacturers use different standards as far as 'length'. BTW I had bought some of the Redcat ones and they are a nice match to the stock 'bones. Good luck.

are you reffering to these dog bones?

http://www.ebay.com/itm/02003-Driving-Dogbone-61mm-2pcs-Behemoth-HSP-HIMOTO-/190547518365?pt=Radio_Control_Parts_Accessories&hash=item2c5d84639d

Yes, those are the same ones.

Thanks guy for the help aapreciated

by the way here is my Marui Samurai


I just want to give her a front dogbones for her grand burial

Oooooo.

I think you have a bit of work ahead of you.

How did you score that old girl.

That looks as bad or worse than the one I snagged at a swap meet a couple of years ago. Are you going to restore it or...