RC10Talk - The Net's Largest Vintage R/C Community

I've almost finished my 10T MMV truck build, but I need a pair of MIP CVDs to complete it. I'm using an oddball tranny with plastic slider cups and RPM truck arms, which is turning into a nightmare finding axles that fit.

I'm hoping to get measurements on MIP CVDs for other applications from other members if possible so I have an idea of what to purchase.

I need MIP CVDs that accept RC10T/T2/T3/GT 1/4" axles, but are about 1/4" shorter in length than standard 10T CVD bones, which measure 3 & 7/16" from end to end. The ball on the end can be slightly larger than the standard 10T CVD bone, as well.

Any help would be greatly appreciated.

Customworks right side GSX offset CVD, or maybe the Losi axel half that has a deeper offset

Charlie don't surf wrote:Customworks right side GSX offset CVD

ya, the wide cw bones are the only ones that come to mind. might be a bit too short though.....