RC10Talk - The Net's Largest Vintage R/C Community

So i've been hit by the Bug....ever since i've always wanted to have one(91 works) but cannot afford. I finally have one (Thanks to Geeforce59). Now my problem, i manage to score a front Belt (ZC 653S, thanks to Pepe) and i need the ZC 658S (M2-96T rear belt). i was wondering does any of you guys here found any substitute (or source or even have spares) for these belts?


Borrowed pics from Bormac (Jason), hope you dont mind sir.

does the M2 - 96 T = to 2mm - 96Tooth and metric?

coz if it did then i think this will fit as replacements.

Rear FineBelts- - but a bit think ; 4MM.
http://beltcorp.thomasnet.com/viewitems/ing-belts-neoprene-timing-belts-metric-pitch-belts/2mr-power-grip-174-gt-174-2-neoprene?


Front FineBelts- 4MM Think.

http://beltcorp.thomasnet.com/item/ing-belts-neoprene-timing-belts-metric-pitch-belts/2mr-power-grip-174-gt-174-2-neoprene/2mr-504?&bc=0|3001011|3001015

any one tried a replacement? or i should wait that someone is generous enough to sell one for me?
- reactions - even violent , comments are welcome.

i would love to run my yoke and would not dare keep it and not enjoy it on the tracks.

and oh... thank you...

I ever have three rear belt 658S M2,but have been sold.only keep one set of these belts, 653S(251T,I do not know the different of 252T) & 658S

i was advise to convert to a 3mm pitch system, but which is better? in terms of being competitive and not having to think of that very elusive fine pitch thingy....