RC10Talk - The Net's Largest Vintage R/C Community

I have a Kyosho Chevy step side from around -84! But I’m looking for replacement truck/pickup body for this truck. My original body is beyond salvageable.
The measurement is as follow:
Wheel base: 275mm (about 11 inch)
Wide: 200mm (about 8 inch)
So help me out guys, I’m open for any suggestions!

here you go?
http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXDA40&P=7

bearrickster wrote:here you go?
http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXDA40&P=7

It would be perfect, but are you certain about the measurement?

I didnt look at the mesurements? its a 1/10 chevy truck body? the rest is up to you?

Well that’s true; I tried to find it on Parma’s home page with out luck…
But it hasn’t to be a Chevy body.

I'm currently trying to find a Chevy body for my Big Brute which has an 11" wheelbase as well.

I haven't looked too hard yet but I did find this in the way of Chevy pick-up truck bodies:
http://prolineracing.com/bodies/1980-chevy-pick-up-t-e-2-5-maxx-revo-savage/
It might be too skinny for your application though.

Here's what I found by Googling "Parma 10200":

http://www.rcmart.com/catalog/rc-road-parma-body-chevy-stepside-pick-10200-p-20258.html

-.040 thick Lexan

-255mm wheelbase (10")

-190mm width (7.5")

Lowgear wrote:I'm currently trying to find a Chevy body for my Big Brute which has an 11" wheelbase as well.

I haven't looked too hard yet but I did find this in the way of Chevy pick-up truck bodies:
http://prolineracing.com/bodies/1980-chevy-pick-up-t-e-2-5-maxx-revo-savage/
It might be too skinny for your application though.

This body looks promising, but it’s only 170mm wide! The tires will stick out a bit, but that’s no problem I think.

Hcp22 wrote:

Lowgear wrote:I'm currently trying to find a Chevy body for my Big Brute which has an 11" wheelbase as well.

I haven't looked too hard yet but I did find this in the way of Chevy pick-up truck bodies:
http://prolineracing.com/bodies/1980-chevy-pick-up-t-e-2-5-maxx-revo-savage/
It might be too skinny for your application though.

This body looks promising, but it’s only 170mm wide! The tires will stick out a bit, but that’s no problem I think.

The same body, $7.50 cheaper
http://www.losipartshouse.com/servlet/the-31461/PRO324500-1980-Chevy-Pick-dsh-Up/Detail

A clodbuster has a 10.63" wheelbase. The juggernaut has an 11" wheelbase. Maybe one of those bodies would come close.