RC10Talk - The Net's Largest Vintage R/C Community

I'm trying to replace idler gear bearings in my RC10 6 gear transmission - but do not have a allen wrench small enough - where do I find one ???

Thanks
Craig

I posted the same question a while back. The wrench comes in the package with the screws, so you can just order a package of screws and you will get the wrench with it. Last time I checked Tower had them in stock, and you could probably find them on ebay too.

Thank You very much for the help !

I called associated and they sent me one for free. Arrived in 3 days. Nice surprise!

0.9mm hex, several options which are better, but not cheaper, than the L-wrenches:

http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXVWD4&P=7

http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXXYN6&P=7
or
http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXWRS6&P=7


I have the first one, works great.

Thanks to all for your help - I went and ordered two of these sets for my two RC-10's from my local hobby shop !!
http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LX2795&P=7

Thanks Again
Craig

i snagged one of these from mcmaster and am quite happy !
http://www.mcmaster.com/#7043A12

works much better than my sanded down .050"