RC10Talk - The Net's Largest Vintage R/C Community

Posted: **Tue Feb 22, 2011 9:20 pm**

???

???
Thanks!

Posted: **Tue Feb 22, 2011 10:23 pm**

You have a 870C motor plate and the nylon is the cap to hold the bearings in place. No idea on the small CF piece or the decals.

Jake

Posted: **Tue Feb 22, 2011 10:41 pm**

those parts could also be yr4. the small black horseshoe looking part is a lower bulkhead plate/bumper for the original yr4.

Posted: **Wed Feb 23, 2011 12:51 pm**

The Horse shoe shaped part is for adjusting the rear bulkhead/rear belt tension. The part mounted to th ebottom of the YZ-10 and replaced the two smaller plates used on some of the cars.

Posted: **Wed Feb 23, 2011 4:08 pm**

hi mate! the graphite part is meant for a 93 works car

Posted: **Wed Feb 23, 2011 4:30 pm**

ZC-302C specifically

Posted: **Wed Feb 23, 2011 4:36 pm**

aip47-2008 wrote:ZC-302C specifically

show off

Posted: **Wed Feb 23, 2011 4:52 pm**

The part # is from a touring car maybe even the GT4.

RC10Talk - The Net's Largest Vintage R/C Community

Please help identifying parts and decals

Please help identifying parts and decals

Re: Please help identifying parts and decals

Re: Please help identifying parts and decals

Re: Please help identifying parts and decals

Re: Please help identifying parts and decals

Re: Please help identifying parts and decals

Re: Please help identifying parts and decals

Re: Please help identifying parts and decals