RC10Talk - The Net's Largest Vintage R/C Community

where can i find a complete list of a&l products and instructions for rc10 kit

look in the scan archives.

What kit do you need the instructions and parts list for? I still have them all may need to scan them into the computer. Daryl

i'm looking t start a rc10 project, i want to see all the options there were.i think i want to do the graphite chassis setup. do you by any chance have any left over parts?

I have
front and rear shock towers for stock suspension

everything for a Graphite chassis trailing arm kit except the chassis

Working on getting steering kits going again most likely three months out

6 and 7 cell battery hold downs

Trailing arm conversion kits for tube chassis

Trailing arm conversion kits with our G-10 tube replacement

Working on a way to get some RC/10 Lethal Weapon belt drive trannys for you guys too.

I am sure there is more just need to do another inventory.

Daryl, I have a A&L Graphite ultima I have had for years and I always loved it, Cool car to drive and I am in the process of starting to restore it. I would Like to do a RC10 A&L car as well, I might be interested in a kit if you get some made. Randy

Can not find a source for the Chassis blanks, no one make Graphite chassis plates anymore. I have been looking but no luck for far.

Daryl Lane wrote:Can not find a source for the Chassis blanks, no one make Graphite chassis plates anymore. I have been looking but no luck for far.

i guess composite craft is back in business again. might be an option.....

www.teamcompositecraft.com

Daryl, I'd be interested in the steering kits if those get produced.

Daryl Lane wrote:I have
front and rear shock towers for stock suspension

everything for a Graphite chassis trailing arm kit except the chassis

Working on getting steering kits going again most likely three months out

6 and 7 cell battery hold downs

Trailing arm conversion kits for tube chassis

Trailing arm conversion kits with our G-10 tube replacement

Working on a way to get some RC/10 Lethal Weapon belt drive trannys for you guys too.

I am sure there is more just need to do another inventory.

how different is the fiberglass from the graphite? if i did a fiberglass set up, later cold i move it to one of your graphite chassis? can you pm me pricing?

scr8p wrote:

Daryl Lane wrote:Can not find a source for the Chassis blanks, no one make Graphite chassis plates anymore. I have been looking but no luck for far.

i guess composite craft is back in business again. might be an option.....

http://www.teamcompositecraft.com

Thank you, I have pm'ed them, we shell see.

since everyone is starting a wish list for daryl here is my wish, a&l chassis brace stiffner's, ultralight plastic stealth outdrives, and some buggy bodies.