Page 1 of 1
LiPo to fit vintage battery trays
Posted: Wed Jan 19, 2011 10:23 pm
by dldiaz
Can anyone recommend a currently available LiPo battery that will fit nicely in the stock battery tray of an RC10 or a JRX-2?
I bought a cheap LiPo intended for the 1/16 Traxxas models, but, it's just too small for even the smallest 1/10 scale battery tray - I might wrap it with a little bubble wrap (to fit snug) for use it in my Grasshopper...
Re: LiPo to fit vintage battery trays
Posted: Wed Jan 19, 2011 10:27 pm
by Daddeo
SPC makes some very nice, well built packs that should fit no problem. As long as you keep your battery in the range of 5K to 6.5K in 7.4V configuration. Check them out here:
http://www.spcracing.com/index.php?categoryID=13
I suggest getting the 5K 7.4V pack as I know it will fit with no problems and has plenty of juice.
Re: LiPo to fit vintage battery trays
Posted: Wed Jan 19, 2011 10:54 pm
by sneako43
SMC packs fit great. I use them in my T4, SC10, and 10T. I had to move the battery tray up a bit and use double-sided tape to secure it to the chassis but the width is perfect.
I have the 4100mah packs...long run time even with a 10.5 Brushless. Barnfloor.com has them at pretty good prices.
http://thebarnfloor.com/catalog/advanced_search_result.php?keywords=smc%20lipo
Re: LiPo to fit vintage battery trays
Posted: Thu Jan 20, 2011 4:43 am
by Lonestar
Any of the "car-shaped" lipos designed for 10th scale cars fit nicely into the rc10 trays... they were slightly too large for subc's, they're perfect for lipos
Paul
Re: LiPo to fit vintage battery trays
Posted: Sat Jan 22, 2011 4:27 pm
by dldiaz
Lonestar wrote:Any of the "car-shaped" lipos designed for 10th scale cars fit nicely into the rc10 trays... they were slightly too large for subc's, they're perfect for lipos
Paul
Yes, I suppose this question was more for my JRX-2's - the battery tray seem to be a bit smaller than the RC10's, my LiPo's don't quite squeeze into the JRX-2 tray...
Re: LiPo to fit vintage battery trays
Posted: Sat Jan 22, 2011 5:54 pm
by THEYTOOKMYTHUMB
As stated above the SMC packs work great. Here's a 3s option. I have footage of this pack in 3s and 4s in a Boomerang with a Castle 4600kv, but have yet to upload to youtube due to scheduling conflicts...
http://www.rc10talk.com/viewtopic.php?f=40&t=13911
Re: LiPo to fit vintage battery trays
Posted: Wed Feb 09, 2011 11:37 am
by JK Racing
In my LXT (molded chassis) I can easily fit the Orion 3200 & 3600 packs. I cannot fit my Reedy 5K or Checkpoint 5.4K batteries though.
Re: LiPo to fit vintage battery trays
Posted: Wed Feb 09, 2011 12:38 pm
by kaiser
i have two 5k hardcases, one fits and one doesn't.
but i like a light car and have been using turnigy 3k 40c soft packs with great results.