RC10Talk - The Net's Largest Vintage R/C Community

Does anyone know the size and count of all the screws needed for an "A" stamped RC10? Actually, I need the screw size for the chassis screws that attach the tranny to chassis, steering blocks, etc. I forgot the car at home and I'm 220 miles away. I'm in the valley where there is a Bolt and Screw shop that has every imaginable bolt and screw, but I don't have the size and count of screws needed. Can anyone help? Thanks gents.

18 or so 8-32 x 1/2" is for the chassis/trans/mounts
The servo saver gets 8-32x7/8"

The above heads on those screws have a 100 degree angle

4-40x3/8" and 4-40x5/16" are good to have also.

You the man Transamman. Thanks Bro.