RC10Talk - The Net's Largest Vintage R/C Community

im starting to rebuild a Jrx Pro Se, I want it to be like the racer i had circa 92. I just acquired a 2.19 XX tranny case gray. What im looking for are the parts #s or a list of what i need to complete it. i need a 2.19 top shaft and gear. what about the idler gear and diff gear, how many teeth which gen should i look for. Anyone already do this? i should of never sold my pro se to get that double x back in the day..... lol.

thanks guys,

You mAy want to try vintagelosi.com it has all you need as for the partlist.

Read thru the links below and you can get the links and also the site where to get the parts, if your lucky,
Sorry i'm using my phone and its a. It difficult to change threads.

http://www.rc10talk.com/viewtopic.php?f=27&t=18950
http://www.rc10talk.com/viewtopic.php?f=27&t=18832

And also the guys here will surely help you. Just shout!!!! Hahahah

Jun.

i may hav easked this before, but could the entire internals of a xx car tranny be used in the 2.19 xx retrofit for the jrx's? Seems like it would go? If so, may be easier to just source a xx parts car or tranny....

thanks guys.

losiXXXman wrote:i may hav easked this before, but could the entire internals of a xx car tranny be used in the 2.19 xx retrofit for the jrx's? Seems like it would go? If so, may be easier to just source a xx parts car or tranny....

I belive the gears are the same but the case's are very different.

Thanks Bear-

I knew the case was different, I have raced xxs and xxcrs BITD, and a JRXT w/ LRM was my first "race" vehicle. Just wasnt sure about the transferability of the internals. I actually looked back a few pages and HAD asked this before, and had gotten the answer...Absent-minded me couldnlt remember !