RC10Talk - The Net's Largest Vintage R/C Community

I am so close to getting my rc10 running, but I can't find a good spot to mount the servo.

I am using ball joints on the servo arm and the one thing up front that the steering rods are connected to (like 2 T's with a center link and one has a little arm off of it that needs to be pushed forward and backwards for steering.)

I can't find a good place to mount the servo. I am going to attach everything else with double sided tape, but I want the servo to be hard mounted, so it can't move at all.

Any help at all would be great. I will take pictures tomorrow if no one can understand what I'm talking about.

This section of the manual should help you! http://www.teamassociated.com/pdf/cars_and_trucks/RC10/Original/teamcar_manualc.pdf