RC10Talk - The Net's Largest Vintage R/C Community

While I cleaned up a 10L chassis for another member I decided to build a little more on my 10L chassis. Don't know much about these things. The front suspension is from Raceco. I built that new from the bag. If anybody has more info on what it's built with then give out a shout.

Well from the looks of it you have an HPI Damper Post brace, and the rear Pod "Diffuser" is also more than likely from HPI. The Motor Mount is an optional Associated piece. The right Diff hub, may be a Technacraft item. The Damper Discs are Parma/PSE Teflon items. I am not sure, but I think if you scoot the servo back some you should be able to run the turnbuckles outside of the front suspension pieces. Other than that you are off to a great start.

I do not know much about the front end though. Rims need no Intro.

Regards,
Maurice

You know sho? I'm a little disappointed with your build! You have lowered your above spectacular standards.

First off, a new spur gear is about 4 bucks! And what's with the romantic lighting for the photos? I don't see any candles or rose petals on that granite counter!

I think its still a "rough piece" and still in progress

drbelleville wrote:I think its still a "rough piece" and still in progress

your right it is. I still got to dig through my box of goodies and dig some good stuff out. I saw that I had a Hyperdrive rear damper to install

shodog wrote: I saw that I had a Hyperdrive rear damper to install

oh oh oh i wana see! hurry up and install it!!

I have a new spur for you too bad I gave the MIP center shock away

ahh, caught the bug did ya. That's a nice looking car. I was going to ask about your tecnacraft wheels, but figured that if you had other 10Ls that they would be in use. And I am too cheap right now. I would feel obligated to do a Nissan car with them if I had them. Kinda glad I don't though, because I want to paint a Gulf themed car. Cant wait to see the hyperdrive rear damper!

I've been working on my 10L for the past week or so. I installed a Tecnacraft Aero-trac kit which allows you to mount the motor on either side so I used a Hyperdrive belt kit. . I also added tecnacraft hubs.

That looks gorgeous!

Any idea on the body yet?

Any idea on the body yet?

This may answer your question

http://www.rc10talk.com/viewtopic.php?f=56&t=27048

I'm on the hunt for a Porsche 956/962 body. I want to do it in a Miller high life beer livery

That's stunning, cant wait to see the body! Great choice too, it should highlight those Tecnacraft's.

best 10l i have seen, and there are more parts to come