RC10Talk - The Net's Largest Vintage R/C Community

Could someone please direct me to the discussion of B2/B3 rear hub carriers with B2/B3 rear arms, and which CVD's to use... I know I was reading all about this in a thread within the last couple months, but, after a good 45 minutes of searching... I cannot find the thread...

I am working with an RC10B3, I want to make the rear track a bit wider - I think the B2 rear hub carriers will do this, so then I want to be sure which CVD's to order: B4 or B44 (front or rear B44)???

Thanks for any help.

The B2 rear hub carrier is flush with the end of the arm, but the B3 arm and carrier space it out further. Also you can run the B4 hubs, combined with the B44 rear CVA to make it wider, but it is beyond roar width-