RC10Talk - The Net's Largest Vintage R/C Community

Newbie here. I've been trolling this forum for a few months now and recently became a member. I have read a good 80% of the forum excluding the on road stuff, nothing against it just figure I'd stick to what I know for now. I have already acquired a couple of starter cars that I got from eBay. The sad thing is that the last one was complete junk. I'm hard pressed if I could salvage two screws, but that was my fault it was a bad call cause I let my emotions get to me in BIN price with just one picture and I got burned. It was so bad I didn't even take pictures of it. Did not want to have evidence and bad memories of that junk. I do have pictures of the other two which I will post later on. blah, blah, now to the real question. I found this shock tower which I think is a really early one but I'm not sure if it is or not and which is it, ok here is goes.

nothing really 'early' about it, it is however the correct shock tower for all gold pans with short front arms.

Thanks for the response. The thing is, that I thought there were two types of those. Milled and stamped. Now the question is which one is that.?

Stamped, you can tell because of the bright white edges and holes-

Thanks for the info, I appreciated.