RC10Talk - The Net's Largest Vintage R/C Community

Where can I get another 1/8" reamer,for the hinge pins? Thanks Johnny

one of the easiest places is http://www.mcmaster.com http://www.mcmaster.com/#reamers/=7nqv01 they have a huge assortement of reams. I'd go with a slightly oversized ream for 1/8 inch hinged pins. Get yourself a .1255, .126, and a .1265 they are relatively cheap and different plastics will cut/resize differently, so if you use a .125 ream you won't be able to but a 1/18 pin into the hole you just reamed in palstic.

Thanks Mike,called McMaster the sales guy didn't know his A__ from a hole in the ground. Thanks JohnnySr

http://www.mcmaster.com/#catalog/116/2465/=7nw8jr

This will bring you right to the page. The sell alot of different sizes.

Thanks Mike, found them JohnnySr