RC10Talk - The Net's Largest Vintage R/C Community

I've had my CR-01 crawler for more than a year now, but finally decided to post some pics on here.

Here are a list of the mods:

- Junfac heavy duty steering links powdercoated satin black
- Junfac skid plate powdercoated satin black
- Junfac rear axle lockouts powdercoated satin black
- Junfac driveshafts
- Junfac servo plates powdercoated satin black (front and rear)
- Tamiya optional aluminum dampers
- Tamiya CR Tuned 35T motor
- 3Racing gold barrel springs painted black (not shown)
- Removed cantilever system
- Sratch-built aluminum front bumper and snorkel
- RC4WD 2.2" Mudslingers w/o foams
- Frame rails powdercoated satin black
- Pro-line roofrack, shovel, axe & pic; home-made recovery straps,
bungee cords & sleeping bags, spare driveshafts

I've updated my CR-01 over the last few months with some new parts and wanted to snap some pics while it's still presentable.

These are what I've added:

- Pro-Line 2-door JK Wrangler Rubicon body
- Pro-Line 1.9" Interco TSL Swampers
- Associated rear body posts with aluminum and velcro mounts
- G-Made/Junfac 1.9" VR01 beadlocks
- Holmes Hobbies BRXL waterproof brushed ESC - This thing is rediculous!
- Holmes Hobbies TorqueMaster Expert 27T motor - Stock drivetrain parts don't stand a chance!
- Venom 3s 5000mah LiPo - Makes my old 2s seem like a AA!
- Pure-Tech battery straps
- Traxxas T-Maxx/E-Maxx shortened driveshafts - Gotta have at least one Traxxass part, right?
- Losi MRX3000 2.4GHz receiver that's been Plasti-Dipped
- Radio Shack medium project box that's been fully waterproofed
- Tamiya reinforced drive shaft & diff lock sets and reinforced outer wheel axles
- Both axle housings and bearings filled with marine grease
- Hitec 645MG servo that's been marine-greased and Plasti-Dipped
- Converted to full droop setup with 3-hole pistons and Tamiya light shock oil, removed all spring perches
- Upper and lower links powdercoated satin black








Flexin' on the mini RTI ramp:

Nice CR-01 I,m also planning to install the servo mount in the front sooner or later