RC10Talk - The Net's Largest Vintage R/C Community

does anyone have a suitable (or even original) option for the ball ends for kyosho cars?

i was looking at these
http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXJJ81&P=7

i know or think the kyosho ball is 2.6mm? i think thats right, do these work?

for pivot balls, does anyone know if these are 2.6? they are kyosho
http://cgi.ebay.com/3Racing-64-Ti-Pivot-Ball-9mm-V-One-RRR-FW05-RR_W0QQitemZ180446748424QQcmdZViewItemQQptZUK_ToysGames_RadioControlled_JN?hash=item2a0376df08

of course lol

i assume these are probably the original kyosho ones rod ends here too (with the skinny one attached)

http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXWZ07&P=7

i would think so. sometimes the most obvious is the least obvious place to look lol wanna toss in some st-15 parts for me on the order ?

My Optima and Ultima has a mixture of Losi studs with RPM ball cups and Tamiya pillow balls with Tamiya connector cups.

I hate the Kyosho ball ends. They always bind and pop off easy.

Why when I had all these listed on the bay no one needed them