Page 1 of 1
Custom Works Intimidator "in progress"
Posted: Sun Jan 17, 2010 9:07 am
by drbelleville
Here is my recently acquired Intimidator. I plan to get it up and running as close to period correct as possible, a Tekin 411P esc, Futaba 1024 PCM Radio gear, a Trinity Dirt Oval Motor and some Sanyo 1300 Nicd Cells. Don't know which body yet, but we'll see as it goes.
-Oh anyone have an instructional booklet?
Re: Custom Works Intimidator "in progress"
Posted: Fri Feb 26, 2010 5:05 pm
by Lonestar
Very cool project
Any idea about the 411P's limits as I have one for my projects too, but not sure how much it'll take before it goes poof?
thanks!
Paul
Re: Custom Works Intimidator "in progress"
Posted: Sat Feb 27, 2010 10:57 am
by drbelleville
I have the booklet for the esc, once i get home i can send you a scanned copy
Re: Custom Works Intimidator "in progress"
Posted: Sat Feb 27, 2010 3:06 pm
by Lonestar
drbelleville wrote:I have the booklet for the esc, once i get home i can send you a scanned copy
That's cool, thanks... the Amps rating is 300A that's pretty much all what the booklet says... but I found on the tekin archive today that the other top of the line speedos of that time also were rated 300A or so... I'll give it a shot
Paul
Re: Custom Works Intimidator "in progress"
Posted: Sat Feb 27, 2010 9:35 pm
by drbelleville
Its not worth burning up, does yours still beep and the lights works?
Re: Custom Works Intimidator "in progress"
Posted: Sun Feb 28, 2010 4:06 am
by Lonestar
drbelleville wrote:Its not worth burning up, does yours still beep and the lights works?
I haven't hooked it up yet, to tell you the truth... but I shall know soon enough
Paul
Re: Custom Works Intimidator "in progress"
Posted: Sun Feb 28, 2010 1:04 pm
by PBR Allstar
Needs a set of white wheeled s'cones and a batwedge body with a big silly side damn!
ahh,, the good old days!