3/32" dia Stealth diff balls?

Post by **DerbyDan** » Mon Jan 11, 2010 8:00 am

I was reading the AE manual for thr Worlds RC10 & it makes a point of stating that only the Associated 3/32" carbide diff balls should be used & if replaced with a new set they should even be all from the same batch!

I just wondered how critical is this? I'm re-building my diff but noticed that a couple of the balls have dull spots on them, I have a whole bunch of brand new 3/32" balls that I got with a Lot of old Losi spares I brought recently - would it be that much of an issue if I used these? Or should I buy a new AE set?

Thanks in advance

Dan

Post by **scr8p** » Mon Jan 11, 2010 8:25 am

well of course their gonna say.... only use the associated diff balls.

it doesn't matter what brand they are, just replace all of them.

Post by **DerbyDan** » Mon Jan 11, 2010 9:09 am

scr8p wrote:well of course their gonna say.... only use the associated diff balls.

it doesn't matter what brand they are, just replace all of them.

I thought as much - thanks scr8p

RC10Talk - The Net's Largest Vintage R/C Community