RC10Talk - The Net's Largest Vintage R/C Community

I have these jrx2 links but I have never seen them before anybody have an idea??

No...but cool!

never seen them before. Not quite sure how they would even work on a jrx-2 unless they are part of a completely custom rear end. The stock side links are different length upper/lower and those appear to be the same. also they have no place to mount shocks.

good point but the were on as links on a jrx2 I got on ebay oit was trash just parts it used ball ends It didnt have shocks so I dont know how they mounted?

How were they mounted? The links with 2 ball cup ends have the opening on the same side. The stock links have the balls mounted in opposite directions on the hub carrier from the bulkhead.

I belive the ones that take the stock ball went on the bottom and the other ones were on the top it wasnt complete so I didnt pay to much attenion to them.

Send Rich a PM. He might know. Keep in mind he probably hasn't been around the forum in a while. Hopefully he'll check his PMs.

mrlexan wrote:Send Rich a PM. He might know. Keep in mind he probably hasn't been around the forum in a while. Hopefully he'll check his PMs.

who is Rich?

hey Guys,

I remeber rick first posting these parts last year. I always thought that it was some kind of RPM upgrade for the 5 link.

Rummaging through my LHS's junk bin, I found a set of those and they were made by HPI for one of their older trucks.

Regards,
Roger

That makes sence they were on a Jrx2 so I thought they were some crazy upgrade someone tried to come up with.