RC10Talk - The Net's Largest Vintage R/C Community

Going to switch out all the bearings in my goldpan with a 6 gear trans. What sizes will I need?

2) 3/8x5/8

2) 3/16x5/16

1) 1/4x3/8 FLANGED

5) 3/16x5/16 FLANGED

i'm not sure what front rims you have, and which model goldtub 6 gear car you have, but here's what you'd need to do an entire car (original or c.e.):

4) 3/16 x 5/16 flanged (front jelly bean rims)
4) 3/16 x 3/8 plain (front 2.1 3 piece rims)
4) 1/4 x 3/8 flanged (rear hub carriers)

now for the 6 gear trans:

2) 3/16 x 5/16 plain
5) 3/16 x 5/16 flanged
1) 1/4 x 3/8 flanged
2) 3/8 x 5/8 plain (only needed if you want to use these in place of the dust shields and retainers on the outdrives)

scr8p thanks for the catch. I forgot opposite ends of the diff shaft are different in the bearing adapters.