RC10Talk - The Net's Largest Vintage R/C Community

I used to race the chassis many years ago, and had fallen in love with its "uniqueness". It had its quirks, "Pencil graphite" lamintaions separating, front end getting tweaked rather easily. But all together a great chassis.

I have collected a few over time, which I will whitle down to three cars. They are 2 ea EV10 Deluxe and 4 ea EV10 Standards

That would be dialed for lipo

they fit like a glove, have already run one with lipo and 13.5T Brushless, is still very drivable.

Still have my Evo 10ss, love those cars

POst some pics, did the EV10ss not have the optional front end adjustment holes like the deluxe? And also the Purple Hardware on the front end as well?

It's burried beneath a mountain of stuff (unrestored) if you post a pic of the difference I can tell you, and it was all raw alum-no purple

Hi i have a 10F version you know were can find Turnbuckles for the front end?

Wow this is an old post.... 11 years

I would say ebay is your best bet.

I have tried but no luck.
Thanks anyway

Just replace them with aftermarket parts...most of the stuff used are stock parts anyway, except for the graphite bits and the pod pivots.

Trinity parts are very hard to find for their more popular cars, and close to impossible to source for some of their later models - I have had a Switch Blade 2 oval car that came mostly complete for over a decade and never managed to find the two parts that were missing (or actually saw any SB2 parts on Ebay... )