ball bearing steering question.
Posted: Fri Dec 04, 2009 11:47 pm
I have a black ball bearing steering kitt that came with my team car and the bearings are rusted fom sitting so long. what size are they? anyone have an idea??
RC10Talk - The Net's Largest Vintage R/C Community
ball bearing steering question.
Page 1 of 1
Re: ball bearing steering question.
Posted: Fri Dec 04, 2009 11:52 pm
probably 1/4 x 3/8 flanged
Re: ball bearing steering question.
Posted: Sat Dec 05, 2009 12:47 pm
Hi.
To be clear...
Usually, they are the same than in the rear hubs
To be clear...
Usually, they are the same than in the rear hubs
Re: ball bearing steering question.
Posted: Mon Dec 07, 2009 10:27 am
the ones in mine are un flanged? guess ill half to get a micrometer to check them.
Re: ball bearing steering question.
Posted: Mon Dec 07, 2009 5:35 pm
well, maybe your car has an mip steering kit. that's the only one i could think of that would have plain bearings.
pics would help.........................
pics would help.........................
Re: ball bearing steering question.
Posted: Tue Dec 08, 2009 7:33 pm
this is the same one it's on ebay right now. i couldnt take one of mine now.
its made by Houge Enterprises
its made by Houge Enterprises
Re: ball bearing steering question.
Posted: Tue Dec 08, 2009 8:11 pm
every one of the houge bellcranks i have, or have had, had the bearings i stated above.
Re: ball bearing steering question.
Posted: Tue Dec 08, 2009 8:20 pm
thanks im gonna add them to my Avid order tomorrow.