rpm team car bulkhead and worlds tower???

[lowrydesign]

has any one tried to use a rpm team car rear bulkhead with a worlds rear tower??

do the holes that have to be drilled into the shock tower actually line up ???

[Charlie don't surf]

has any one tried to use a rpm team car rear bulkhead with a worlds rear tower??

do the holes that have to be drilled into the shock tower actually line up ???

if you can do without the top mounting screws they mount up fine, if you did try to drill the bulkhead, you wouldn't have enough "meat" because of the hole in the bulkhead

[lowrydesign]

if you can do without the top mounting screws they mount up fine, if you did try to drill the bulkhead, you wouldn't have enough "meat" because of the hole in the bulkhead

what about the upper hole your supposed to drill into the tower.. where does it land??

[Charlie don't surf]

too close to the relief hole to drill in my opinion

[lowrydesign]

too close to the relief hole to drill in my opinion

crappy...... that combo looks so good too

[Charlie don't surf]

Actually, I just re-looked at it, looks like there is enough--thank god I finally have my Nikon back!!

[lowrydesign]

Actually, I just re-looked at it, looks like there is enough--thank god I finally have my Nikon back!!

would you actually drill the bulkhead.. i know i would.. only cause i have a used one that is dyed black.....

[Charlie don't surf]

Yoda says not I

[Asso_man!]

Actually, I just re-looked at it, looks like there is enough--thank god I finally have my Nikon back!!

maybe you should relocate one of the rear ball studs or is this a special "racer" trick?

[Charlie don't surf]

I'm still torn between using RCPS or Tecnacraft's, the car is currently mocked up with tecna's on the right side, RCPS on the left--and the RCPS are a little longer than the tecna's--hence the difference in the ball stud location. Nice catch though

[jwscab]

sounds like a perfect opportunity to fab your own rear tower with some extra meat for the 2 mounting holes........using the worlds tower as a template.

[slow_jun]

nice, thats what ive been looking for?rear Bulkhead and Tower, where did you get it? can you send the links?

thanks in advance.

[blown5.0]

Slow_jun - these parts are no longer available, your only hope is to keep an eye open for some to pop up in the classifieds or Ebay.