Page 1 of 1
Old RPM RC 10
Posted: Mon Feb 12, 2007 3:18 pm
by Sharkman
Fellas,I just about finished this one , still needs a few goodies but she's close. "A" chassis drilled for Stealth,RPM Rear bulkhead w/ a-arms,and up-rights,wide front arms,steering bell-cranks,and a set of ..... yup RPM white ball-cups.Lastly the only pair of T-craft buckles I own.I have a line on a new motorplate (un-hacked),and a single t-craft buckle for the center link.I have absolutely zero gold shocks anymore,so teamz will have to do for now,the 1/4" CVD's were just new and in stock. Hope you like it.
Posted: Mon Feb 12, 2007 3:20 pm
by Sharkman
nudder one
Posted: Mon Feb 12, 2007 3:20 pm
by Sharkman
nudder two
Posted: Mon Feb 12, 2007 3:21 pm
by Sharkman
nudder three
Posted: Mon Feb 12, 2007 3:22 pm
by Sharkman
last one
Posted: Mon Feb 12, 2007 3:44 pm
by justinspeed79
Nice!
Posted: Mon Feb 12, 2007 7:16 pm
by superfly
AHHHHH that white plastic!!! SO BRIGHT!!!! SO NICE!!! I"M BLINDED!!!!
Nice car boss
Posted: Mon Feb 12, 2007 8:29 pm
by scr8p
looking good dan.
if that line on a tie rod for your bellcrank falls through, i got ya covered.
Posted: Mon Feb 12, 2007 8:39 pm
by shodog
looks like someone has a secret stash of tecnacraft turnbuckles
Posted: Mon Feb 12, 2007 8:43 pm
by scr8p
shodog wrote:looks like someone has a secret stash of tecnacraft turnbuckles
nope, just that one.
Posted: Mon Feb 12, 2007 9:18 pm
by Ron Jeremy
I didn't know RPM made bellcranks. Those look pretty nice.
Posted: Tue Feb 13, 2007 1:43 am
by carloco8
Ron Jeremy wrote:I didn't know RPM made bellcranks. Those look pretty nice.
Yup, bearing and non-bearing. White plastic had bearings and black plastic had no bearings, right guys?
Posted: Tue Feb 13, 2007 9:19 am
by Sharkman
Thanks all for the flowers. Carlo' I remember seeing white peices somewhere,not sure of the plastic/bearing difference though.I'd be interested in a white set if this is the case.I'd trade the black with a bit of coin
Jason,.Thanks for lookin out.I'll get with you asap if the line "breaks"
TTYS!!
Posted: Tue Feb 13, 2007 6:20 pm
by carloco8
Sorry Sharkman, I don't have either type, lol. I'm just basing my reference off of seeing them on ebay (both types) and the bearing types on scr8p's and hoopty's rpm 10s.
Btw, nice car! I noticed that you have one of those neoprene gaskets on it too!