RC10Talk - The Net's Largest Vintage R/C Community

Hey all pardon my noobness but im just wondering if rc10t2 or t3 universals or cvd's will fit the original rc10t truck. Im converting my 10 buggy to a staduim truck and bought the T rear end suspension parts but one of the universals are slightly bent plus i want to use 3/16 axles instead of the 1/4 axles that cam with it. Im also planning on using Losi rear hub carriers to fit the axles. Is all of this possible?

Dunno about the losi hub carriers but the CVD's/universals are the same length in RC10T, T2 and T3.

ser3100 wrote:Hey all pardon my noobness but im just wondering if rc10t2 or t3 universals or cvd's will fit the original rc10t truck. Im converting my 10 buggy to a staduim truck and bought the T rear end suspension parts but one of the universals are slightly bent plus i want to use 3/16 axles instead of the 1/4 axles that cam with it. Im also planning on using Losi rear hub carriers to fit the axles. Is all of this possible?

T2 and GT 3/16 CVD kits will work. The T3 bone is longer! Not sure about the Losi hubs, that's just wrong to put a peasant part on a Godly car!

I know i know about the Losi thing. I knew i was gonna get flamed for that one..but i just figured i have some laying around and i know the bearings will fit that axle.

The Losi hubs that will work (ie correct spacing) are LOSA2038, and the current buggy hubs from the xxx-cr, any other losi hub would require a B4/T4 outer cvd, or Losi outer cvd

were these the hubs that came with the OG jrx2/pro?

Thats the 2038 that came with the Pro--

You should still be able to find GT rear hub and hub carriers.

My 10t is sporting T2/GT CVDs w/o a problem.



MOmo