Page 7 of 7
Re: W5061 Universal Swing Shaft
Posted: Thu Sep 03, 2015 12:21 pm
by aip47-2008
esaresky75 wrote:RichieRich wrote:I have to say, never have I ever imagined that universals/CVDs for the Kyosho Rocky would generate 4 pages of posts in a thread.
Actually it started out as a CVD solution for Ultima/Optima but I inadvertently hijacked the thread.
It's not even over yet either. I have two sets of Kyosho UM510 coming. They are 62.5mm but with an axle that is 2mm longer than the LA245. If the specs are correct, then an off the shelf 12mm hex hub will work without machining.
NO F---ing way did this thread start this way. It started simply with me sharing a link to Kyosho USA showing W5061 universals as still available. 
Then it was hijacked completely!!!! 
Re: Not my Thread anymore! Hijacked. Please delete ME!!!!
Posted: Thu Sep 03, 2015 12:44 pm
by Coelacanth
I don't understand what the problem is, Aaron...there's a lot of useful information and detailed specs throughout this topic.
Re: Not my Thread anymore! Hijacked. Please delete ME!!!!
Posted: Thu Sep 03, 2015 1:10 pm
by aip47-2008
Coelacanth wrote:I don't understand what the problem is, Aaron...there's a lot of useful information and detailed specs throughout this topic.
No problem, just a fact
Re: Not my Thread anymore! Hijacked. Please delete ME!!!!
Posted: Fri Sep 04, 2015 1:02 am
by RichieRich
Wait, what? This is one of the most informational threads here.
Re: Not my Thread anymore! Hijacked. Please delete ME!!!!
Posted: Sat Dec 19, 2020 6:32 am
by adam lancia
Digging up an ancient feces storm here but I haven't found an answer searching the web yet...
How long are the stub axles on a stock set of UM522 65.5mm driveshafts?
Thanks!
ETA: I just saw part number UMW749 (65.5mm shafts with 3 line stub axles), are these stub axles the same as part number UM510...?
Thanks!
Again...
