RC10Talk - The Net's Largest Vintage R/C Community

mytimac wrote:

LosiXXkid wrote:

mytimac wrote:New prototypes

protos.jpg

Any update on these bad boys???

These are getting track time right now. So far so good. Run them some more and then the real torture test. I am going to let my girlfriend, who can't drive an RC car to save her life, test them. I am scared she will break something else on the car and those will be fine.

Fantastic!!!

What colour do you intend to make them? Or will there be a variety of colours just like the other 3D printed parts??

Nylon front bulkheads would be a god send.. all mine are cracked to one degree or another

Incase you have missed it, I have an area in the Business section now. This the location to now see updates on the 3D printed parts and the status on the XX bulkhead. In fact I just made a post on the XX bulkhead, so check it out now.

http://www.rc10talk.com/viewforum.php?f=90

Dan

This is awesome! Id love to see some transmission cases being made as well. Im not sure how similar all the different model cases are but Id love to buy one for my GTX!

Also post the big update here since it all started in this thread. The new XX bulkheads are available for order. Small amount of 10 available right now and then the whole large order should be done by May 30th.
http://sabulatech.com/storefront/product.php?id_product=2618

If you had been missing the updates and are surprised by this announcement, than you have been missing my posts over in the OLDRC Sabulatech Business section. Head over there to keep updated on future releases. http://www.rc10talk.com/viewforum.php?f=90

Sweet! Just ordered 2 bulk heads.

Excellent work Dan!

The first 10 sold in about 7 hours. If you missed out, don't worry, there will be more right around May 30th.

Thanks to all that bought some of the first run. The response was amazing.