RC10Talk - The Net's Largest Vintage R/C Community

What about the axle nut?

It's hangin' around.

I was thinking of a brushed motor setup, but changed my mind.
.
https://www.rc10talk.com/viewtopic.php?f=40&t=49543
. .

All wired up.
. . .
A little test in the house on the carpet showed that this thing might like to wheelie a bit. I need to find a good location to do some outdoor off road testing.
. . . . . . . .

Group photo! Everyone say cheese! Hey new guy, get in the back row!

Apparently I like to use #8 decals... they probably hide paint blemishes really well.
. .

Frankentruck wrote: ↑Tue Jun 11, 2024 1:06 pm Group photo! Everyone say cheese! Hey new guy, get in the back row!

Apparently I like to use #8 decals... they probably hide paint blemishes really well.

Hmm, which one do I like most...

...umm, number 8!

Dangeruss wrote: ↑Tue Jun 11, 2024 2:39 pm

Frankentruck wrote: ↑Tue Jun 11, 2024 1:06 pm Group photo! Everyone say cheese! Hey new guy, get in the back row!
Apparently I like to use #8 decals... they probably hide paint blemishes really well.

Hmm, which one do I like most...

...umm, number 8!

But this build has #10

Frankentruck wrote: ↑Tue Jun 11, 2024 2:42 pm But this build has #10

Does that mean your next build is going to 11?

Maybe it will be # 8....

Actually my next build will be # 3. It's been waiting patiently for a while.
.

Frankentruck wrote: ↑Tue Jun 11, 2024 4:00 pm Actually my next build will be # 3. It's been waiting patiently for a while.

First time seeing this build..really impressive!

My printer is up and running again after replacing the nozzle heating element so it was time to take care of the battery. I plan to run Lipo but don't need a 5000mah pack. I think these little 2000mah packs have a satisfying amount of run time and they are so light. So I printed up an adapter to fit the battery cup setup.
. .

Absolutely stunning. Any plans for allowing us mere design-challenged mortals access to your printed bits?

JK Racing wrote: ↑Thu Jun 27, 2024 10:42 am Any plans for allowing us mere design-challenged mortals access to your printed bits?

I hadn't thought much about it. There's a couple of fabricated and modified pieces, and I was focused on making it work in nylon material, so I'm not sure the parts would be strong enough in other materials. You can IM me about it and we can discuss. It's one of those things that I'd feel better having it as a kit but my first kit experience wasn't great.

absoluute stunning project