Re: Green parts: not just for ball cups anymore
Posted: Fri May 03, 2019 2:30 pm
The green shade could be contaminated raw plastic pellets, like was mentioned before. That would explain all the different parts having same issue.
Usually if the injection molding machine is contaminated you get some swirls of color not uniform. After a while of running, the green would be removed from machine because of all the new correct color plastic pushed through.
Could also be mold release chemicals contaminating it I suppose. But once again that would be hard to probably get uniform over whole part.
Usually if the injection molding machine is contaminated you get some swirls of color not uniform. After a while of running, the green would be removed from machine because of all the new correct color plastic pushed through.
Could also be mold release chemicals contaminating it I suppose. But once again that would be hard to probably get uniform over whole part.