RC10Talk - The Net's Largest Vintage R/C Community

1851 was sledgehammer

GoMachV wrote: ↑Tue Nov 17, 2020 2:27 am 1851 was sledgehammer

This very well may be the case. However, my OCD will not let me not point out that nowhere on that parts list is the part number "1851".

Don’t remember what this tranny is from

Losi?

That is the LRM, losi’s first trans. Would have been in the jrx2, JRX-pro, Junior series, JRX-T, and LXT

njdriver04 wrote: ↑Tue Dec 01, 2020 12:54 pm Don’t remember what this tranny is from

Losi?

Losi LRM. Silver top gear and no slipper would be from a JRX-Pro or Junior Two/T. The one side gear you can see is one of the low friction ones..A-3024.

Thanks

These reAr arms from a jrx pro?

No , from xxcr , xx4 or xxx

It's from PRP in California from what I can read on the label. And it looks like the rc10 6 gear pattern. But what's the story ?

Easy to carry?

Factory speed holes.

jwscab wrote: ↑Wed Dec 16, 2020 5:29 pm Factory speed holes.

TRX-1-3 wrote: ↑Wed Dec 16, 2020 4:45 pm Easy to carry?

I had a spontaneous laugh - that was great!!!

I've had this motor since Hector was a pup.
I don't have the label any more
No slots in the sides of the can Probably 1990ish.
Yokomo made it for....???
I've been searching for a while but can't find any matches.
Thought it could be RacePrep or maybe Reedy? Or Losi?
Reedy and RacePrep were motors that I would have run.

Chuck

Pretty much all of the motor vendors used yokomo blanks at one time or another. Could be anything but with bushings, it's probably just a 27 turn stocker.

Is the endbell removable?