RC10Talk - The Net's Largest Vintage R/C Community

Set of RCscrewz for the RC10T4 on-road rig. After disassembling and cleaning everything, decided to replace the factory hardware (much of it was a bit rusty) with stainless. Thought all stainless would go good with all the anodized blue pieces I have for the truck. Now on to assembly.

Been diving into 80's Traxxas stuff lately, and still continuing to collect 80's 1:12 pan cars, so it was only natural that this would show up. NOS chassis plates got here before the car, and MCI/TBG combo on the way.

morrisey0 wrote: ↑Wed Feb 23, 2022 11:10 am Been diving into 80's Traxxas stuff lately, and still continuing to collect 80's 1:12 pan cars, so it was only natural that this would show up. NOS chassis plates got here before the car, and MCI/TBG combo on the way.

The mighty Traxxas Fiero? Looking forward to seeing it with the Fiero GTP body on it.

This isn't the vintage of Reedy Modified that I'm hunting for, but it was too good of deal to pass up.
.

I got this beauty, which looks nice next to my other beauty.

You have 2 of them? Whoa!

Clod axle and a set of clod wheels.

Just to be clear, i got the clear body kits of each of these cars, not the cars. As you know, i will be sliding a RC10DS chassis underneath each of these bodies.

Frankentruck wrote: ↑Fri Feb 25, 2022 3:53 pm The mighty Traxxas Fiero? Looking forward to seeing it with the Fiero GTP body on it.

That it is!

Did not come in the post, but I did expand the Traxxas collection with a nice little interstate fieldtrip early this morning.

Now you have to walk around singing the Peter Gabriel Sledge Hammer song!

Frankentruck wrote: ↑Sat Feb 26, 2022 12:55 pm Now you have to walk around singing the Peter Gabriel Sledge Hammer song!

https://www.rc10talk.com/viewtopic.php?f=39&t=22565&start=2040
Half way down the page.

Custom arms and rear guard assembly from iMaterialise.
These are for a rather unique Sand Scorcher build that I'll post in the Tamiya forum when it's closer to being finished.
These arrived about a week and a half after I submitted them - great service.

Got a esc, motor, battery, and charger from an Arrma RTR. None of it looks to have been used much at all.

I normally wouldn't pay something like this much attention but the price was too good to pass up.

LRP ICS

Got another JR XR2i and another Hitec Shredder.
Also got a B stamp pan, Andy's rear arms, front and rear mounts, and some hinge pins.

I got what will become an RC10 B1.5 sometime in the future.
.