RC10Talk - The Net's Largest Vintage R/C Community

Here's an easy solution for those pesky servos that won't fit on your RC10:

Not as bad as some...

That one also has the ultra-rare 45 degree front kick-up plate.

I'm sure you could drill more holes in this one:

I don't think I've posted this. I got this many years ago from a fellow member. Since the one arm mount hole was cracked anyway, I cut the front off and made an ultra molded nose plate.

if 3d printing gets cheap enough ill have one printed up with an actual cheese grater in the bottom.

scr8p wrote:I don't think I've posted this. I got this many years ago from a fellow member. Since the one arm mount hole was cracked anyway, I cut the front off and made an ultra molded nose plate.

That chassis has been pixellated! I guess he couldn't find a bigger drill bit...

Scr8p's a body man, surprised he didn't just use some bondo doesn't look any worse than an old chev

scr8p knows that not everything should be fixed.

cha cha cha chia.

Not really lightweight, but adjustable rear arm mounts.

I think he was trying to copy the Optima frame-rail design.

It looks like they were drilling it out with a pellet rifle...

Wait, is that a a Cadillac logo drilled into scr8ps chassis!?

Swiss-T

They even drilled on the corners of the tub...that takes some skills.