RC10Talk - The Net's Largest Vintage R/C Community

That's exactly what I was doing. It didn't feel like I was really forcing it before it snapped though. Your tip on the shim is noted. Thanks.

NomadRacer wrote: ↑Fri Apr 27, 2018 7:57 am Hi! I have some of the JC Racing Products wheels for vintage rc10's. They are really nice for the 1/4" rear axles. The modern 2.2 tires that I have tried fit great.

http://www.jcracingproducts.co.uk/index.php?route=product/category&path=18

Hello again NomadRacer. Just to confirm, I need four 3/16 x 5/16 x 1/8 flanged ball bearings for the front for the JC Racing wheels right? Thanks.

@Vodzilla

Yes, those are the bearings, two per wheel.

NomadRacer wrote: ↑Thu May 10, 2018 2:46 pm @Vodzilla

Yes, those are the bearings, two per wheel.

I will order them. Thanks NomadRacer.

UPDATE:
So I am looking to purchase inexpensive tires for the JC Racing Wheels for use mainly for running pavement and in the park. I have also recently acquired a RC10B5 with Proline Electrons. Those tires I have almost run down into slicks after a few days from running them at the formerly mentioned surfaces lol. I'd appreciate some recommendation for inexpensive and fairly long lasting 2.2 2WD tires. Thanks.

Any front rib tire would be fine, but you could also run dirt hawgs from proline on all 4 corners. They are kind of tall but work for lots of surfaces and last a decent length of time. On the jc front wheels they will be kind of balloony.

Not necessarily a tire recommendation but a place for discounted/sale tires that I keep a constant watch on... http://www.jconcepts.net/shop/clearance

Thanks for the input jwscab and NomadRacer. I will look into them.