Page 3 of 3
Re: RC10T back from the dead!
Posted: Mon Jun 27, 2011 10:11 am
by cautrell05
Vermin wrote:I have a stock 3-gear Stealth trans and it was as easy as remove old top-shaft and install new top-shaft.
They looked like the GT mounts from this pic is why I was asking.
Nick
Re: RC10T back from the dead!
Posted: Mon Jun 27, 2011 3:00 pm
by Vermin
Nope, those are RPM's with the third mounting hole (not sure if GT's had that) and some dremel work for dogbone clearance.
Re: RC10T back from the dead!
Posted: Mon Jun 27, 2011 5:48 pm
by Charlie don't surf
Cautrell's correct, they are 3deg RPM RC10GT mounts- they are basically the same mount with a slightly different front to rear spacing. But the "third" hole is a dead giveaway- I have some white ones NIP for reference in needed
Re: RC10T back from the dead!
Posted: Mon Jun 27, 2011 6:00 pm
by scr8p
the other dead giveaway they're gt mounts is the loss of wheelbase.......
Re: RC10T back from the dead!
Posted: Mon Jun 27, 2011 9:03 pm
by Vermin
Ahhhhh - RPM's FOR the GT .... got it
Thanks for the schooling guys
Re: RC10T back from the dead!
Posted: Wed Aug 17, 2011 1:04 pm
by evownsu
what tire/wheel combo are you running in the rear?
Re: RC10T back from the dead!
Posted: Thu Mar 01, 2012 10:56 am
by Vermin
evownsu wrote:what tire/wheel combo are you running in the rear?
HPI Mesh wheels with Pro-Line Gladiators - sorry for the delay - was on here poking around as I just had an old 6-gear RC10 given to me and I'm planning a restore, saw that I had missed a question
Re: RC10T back from the dead!
Posted: Sun Jul 20, 2014 10:43 pm
by mfabrizius
i have my original rc10t im getting bacl on the track ... i have the stealth tranny what gears have you foound to work best with a brushless setup ? any help would be appeciated.