RC10Talk - The Net's Largest Vintage R/C Community

too nice

Absolutely awesome work mate - truly a credit to you.

Wish I had the time and skills to do the same - again - great work.

Cheers

Darryn

Hey Mike, are those GT2 steering hubs of a GPM part? Will GT2 front and back hubs work with those arms??

gt2 probably wont fit hinge pin.. they are more along the lines of these.

http://cgi.ebay.com/Associated-RC10GT-blue-aluminum-front-c-hub-RGT1906_W0QQitemZ360231130730QQcmdZViewItemQQptZRadio_Control_Parts_Accessories?hash=item53df72d66a

http://cgi.ebay.com/Associated-RC10GT-aluminum-front-steering-arm-RGT2106_W0QQitemZ360231130765QQcmdZViewItemQQptZRadio_Control_Parts_Accessories?hash=item53df72d68d

http://cgi.ebay.com/Aluminum-Rear-Hub-For-Associated-Rc10GT-Rc10-GT-PRO_W0QQitemZ200433202212QQcmdZViewItemQQptZRadio_Control_Vehicles?hash=item2eaabff424

the rear hubs i remembered having to sand a bit off to make them fit, belt sander does a good job

I figured that much, just was looking to go for some polished aluminum or silver finish suspension parts now that I decided to get some tecnacrafts wheels for my tuber project.

I could alway strip the blue anodizing off, but I've tried it with a gold tub once with over cleaner and it didn't turn out very good, especially in the hard to get at spots.

caustic soda i used to strip these, worked down to bare metal.

Beautiful rail.I think I read some where in the thread you don't plan on running it.I have a car i don't want to run because it is mint.But, Take it to the sand Just one time to get some sweet pix.

What is the cage made from? I know the crawler guys sometimes use brake line but is that too soft for this application?



Sean