yz10 rear wheel adapters for rc10

[aip47-2008]

Very nice collection indeed!!! Do you have any extra's?

[59burst]

I got these adopters for a01butal's project
the hubs with 2 holes are early one. and 4 holes are later one. and they have different offset. the later one is 1mm taller (wider) than the early one.
the early one is from japanese team car BX kit, and the later one from FX that is '92 CE.
as far as I know BX was release in '91 and FX was '92 or '93. and both had stealth.

and, the FX hubs have exactly same offset with the hubs from Suzuki.

[minichamps11]

Any clue what these adapters are for?




And these plastic ones:

[Mr. ED]

the bottom ones are for Tamiya cars; at last they were: you can use them on any brabd that uses 12mm hexes now. they simply go on top pf the hexes. I have a set of aluminium ones like these I use.

The TH-7 ones are as far as I can see for kyosho 4wd cars like the optima and optima mid, lazer etc. the hole is lisghtly conical and the part replaces the old kyosho hex

[minichamps11]

Missed out the photo showing the other side of the TH-7 parts. They seem to have pin slots?

[Asso_man!]

have a look at your avatar and you'll have the solution!

[minichamps11]

Hmm... they're not the same as Schumacher's "Castle" wheel fittings. Why would Yokomo ever make a Kyosho-to-Schumacher wheel adapter!!??!

[Mr. ED]

Hmm... they're not the same as Schumacher's "Castle" wheel fittings. Why would Yokomo ever make a Kyosho-to-Schumacher wheel adapter!!??!

??? I don't follow anymore

Anyway: seeing the backside I must admit TH7 is not what I thought

[aip47-2008]

Here is a Hot Trick set to use Tamiya Hotshot or yz10 wheels on your Kyosho.

[59burst]

I can read japanese barely.
it's TH-7 Schumacher pro[xx] wheel hub.
Procat

[Asso_man!]

I can read japanese barely.
it's TH-7 Schumacher pro[xx] wheel hub.
Procat

exactly what I thought, I was not sure about the model, but I don't know any other brand that made those "castle" adapters.

to clarify a bit: nobody ever talked about Yokomo "Kyosho-to-Schumacher" adapters, Erik was refering to Yokomo adapters for Kyosho cars and I was thinking about Schumacher the very moment I saw the backside of your adapters, then I think you mixed it all up

[minichamps11]

My mistake... Yoke to Schu wheel adapters might be very handy to me

[59burst]

I found some more

early TH-1 with front hubs

later TH-1

Fake 4wd

TH-8 for Ultima

[pedro]

Just going back a bit but most of those adapters were introduced only because of the introduction of the 2.2 inch rims that yokomo were the first to make, meaning anyone and any car could run the new size wheels with the use of the adapters.

Peter

[Bormac]

My mistake... Yoke to Schu wheel adapters might be very handy to me

Ian those wheel adapters are of no use to you. I'll buy them off you.