Page 2 of 2
Re: Kyosho Inferno 10E build
Posted: Tue Aug 24, 2021 8:56 pm
by Drewskie
Quick question, where do you get bodies from?
Re: Kyosho Inferno 10E build
Posted: Tue Aug 24, 2021 10:14 pm
by stickboy007
Re: Kyosho Inferno 10E build
Posted: Wed Aug 25, 2021 3:46 pm
by Drewskie
Nice, the guy is in Canada.
Ok next question is, where can i source shocks like yours? Or, at the very least a good set of shocks.
Re: Kyosho Inferno 10E build
Posted: Thu Aug 26, 2021 11:04 am
by stickboy007
I used RB5/ZX5 standard bore shocks on mine. You can alternately use RB7/ZX7 big bore shocks, with the appropriate spacers to make them fit.
Re: Kyosho Inferno 10E build
Posted: Fri Aug 27, 2021 1:13 am
by Drewskie
For the hub carriers, knuckles and steering... If I used parts off lazers (zx5 zx6 zx7) could optima parts work too?
Re: Kyosho Inferno 10E build
Posted: Tue Aug 31, 2021 10:27 am
by stickboy007
Possibly? I haven't tried...
Re: Kyosho Inferno 10E build
Posted: Tue Sep 28, 2021 9:45 am
by Drewskie
So after some looking I think optima front carriers are a bust as the lower pivot point is on the inside. It would push the track out like 3/4 of an inch on each side if i used those. Not even sure what front shafts I'd need then but certainly not optima ones lol. Unless I swapped in optima front arms... Oh man I'm gonna be doing some math here to figure this one out.