Page 2 of 2
Re: front arms
Posted: Thu Dec 18, 2014 11:15 am
by dirtyolds@vage
Re: front arms
Posted: Thu Dec 18, 2014 11:21 am
by scr8p
something in the 7/32" - 1/4" range.
you will probably need a washer behind the nut, and also a very thin wall socket to fit inside the wheel to tighten it.
Re: front arms
Posted: Thu Dec 18, 2014 12:41 pm
by dirtyolds@vage
Will any associated 12mm hex work or is there a specific one and only? I have found a variety of hex and trying to get the right one.
sc10 9892
b44 9925
Buggy 9890
Re: front arms
Posted: Thu Dec 18, 2014 1:36 pm
by scr8p
any 12mm hex for a 3/16" axle will work. you just have to find one with the correct width. i don't know the mfg. of mine, they were just some plastic ones I had laying in a drawer that kept me at the stock track width.
Re: front arms
Posted: Thu Dec 18, 2014 2:36 pm
by dirtyolds@vage
ok thanks