Re: 3D printed Stealth gearbox housing.
Posted: Tue Nov 19, 2013 4:16 pm
I sure hope so.gomachv wrote:The stealth is due for rerelease anyway so the "shortage" should be short lived.
Just sayin
RC10Talk - The Net's Largest Vintage R/C Community
3D printed Stealth gearbox housing.
Page 2 of 2
Re: 3D printed Stealth gearbox housing.
Posted: Tue Nov 19, 2013 4:21 pm
If you look at the Traxxas Magnum 2,72
The idler is pushed up and the diff is raised
Didn't the TRX-1 use the same size diff gear as the 2,25 stealth ?
I'll have to go dig my TRX-1 out of hiding to compare
The idler is pushed up and the diff is raised
Didn't the TRX-1 use the same size diff gear as the 2,25 stealth ?
I'll have to go dig my TRX-1 out of hiding to compare
Re: 3D printed Stealth gearbox housing.
Posted: Tue Nov 19, 2013 5:12 pm
Hang tight, 60 bux is outrageous for a case! Also, we haven't heard back from Dynotech about the 2.6 cases yet 
Re: 3D printed Stealth gearbox housing.
Posted: Tue Nov 19, 2013 5:18 pm
HI!... Stealth you say? No problem. 
Have a couple black ones around here somewhere too.
Have a couple black ones around here somewhere too. 
Re: 3D printed Stealth gearbox housing.
Posted: Tue Nov 19, 2013 5:18 pm
Sorry double post. 
Re: 3D printed Stealth gearbox housing.
Posted: Tue Nov 19, 2013 5:22 pm
Holy craaap Sell me a black one 
Sell me a black one Re: 3D printed Stealth gearbox housing.
Posted: Tue Nov 19, 2013 5:31 pm
HI!... Got a bunch of 6 gear cases as well.
Re: 3D printed Stealth gearbox housing.
Posted: Tue Nov 19, 2013 5:32 pm
THE H.P FREAK wrote:HI!... Stealth you say? No problem.
Oh oh PLEASE can I have one of those nice shiny white ones ?
Re: 3D printed Stealth gearbox housing.
Posted: Tue Nov 19, 2013 5:43 pm
I have an almost white one with blueish permanent marker on
Would peroxide or is it hydrogen peroxide get it all white ?
Would peroxide or is it hydrogen peroxide get it all white ?
Re: 3D printed Stealth gearbox housing.
Posted: Tue Nov 19, 2013 5:45 pm
Hydrogen peroxide will not remove the marker, you need to use some form of solvent to remove that. The peroxide just whitens the nylon that has yellowed due to time.
Chris
Chris
Re: 3D printed Stealth gearbox housing.
Posted: Tue Nov 19, 2013 6:33 pm
HI!... Make sure to use a ultraviolet light with the Hydrogen peroxide or it basically does nothing IMO.
Re: 3D printed Stealth gearbox housing.
Posted: Wed Nov 20, 2013 1:39 am
What solvent will remove marker and leave the nylon unharmed ??