RC10Talk - The Net's Largest Vintage R/C Community

Hmmm...
I don't think this body matches the ProLine Class 1 buggy:
- the sides are shaped very different
- this body does not have window nets like the ProLine

It also does not match the scoop-less Mirage body shown above:
- their is no "wing" molded into the roof
- there are protrusions over the top of the rear shocks
- the side windows have a forward "roll-bar" molded into them


I got the body and chassis in an eBay purchase several years ago,
I don't know anything more about it.

Problem is that's not a pic of the Pro-Line Vision, this is.


Ultimate RC10 Body Thread

Phin wrote:...Pro-Line Vision Low Profile body
Problem is that's not a pic of the Pro-Line Vision...

Ultimate RC10 Body Thread

Cool thread! I missed that one.

There are certainly similarities to the "Pro-Line Vision Low Profile body" picture above, but it is very difficult to make out the sides.
Are the sides different than those on Eau Rouge's pink body (referenced above)???

Finally pulled the trigger on a World's Car re-release chassis set from Stormer Hobbies (through eBay).
Set includes:
Chassis #6302, Nose plate #6309, Nose tubes #6321,
front body mount with spacers, and various hardware - for $89.95 shipped

Good move!

What's next, drill it into swiss cheese to make it light weight

I'd trim her down for sure though.

I'm thinking stock chassis for this one.
I have so many custom chassis (cut-down, drilled, re-anodized, de-anodized, painted, etc., etc.),
I kinda miss just a wholesome, old-fashioned, from-the-factory chassis.

Can i point out that we need Srs stickers remade..? )
I remember scott and mike running the Hayden road shop.. Just awesome

By The Way -

1) Could someone confirm that these are "Worlds" type steering bell cranks?

2) And that the correct ball bearings would be the [1/4"x 3/8" flanged] bearings?

Best pic I have of the bell cranks at the moment:

those look like the black worlds, could be houge as well though

Would Houge bell cranks also use the 1/4"x 3/8" flanged bearings???

Yes, not sure the exact history, but the houge & worlds were from the same molds. Dont know if AE bought them or if Houge made them for AE. But they are the same part (houge did have other versions, but with revisions over the years to end with the worlds style bellcranks).

Cool! Thanks!

Might-as-well upgrade to a Stealth transmission (thanks 'mikea96'), since the Rere Worlds chassis is already tapped for it... And a few other Rere parts to be installed:

Lets see some photos!

Baby steps: