Page 2 of 2
Re: My old is new / fun runner build.
Posted: Wed Sep 11, 2013 1:03 pm
by GoMachV
That's the same basic way I run my pin router, "one off" stuff gets double sided tape, repetitious work gets screws turned down into pegs
Very cool setup. I need something like that....one day!
Re: My old is new / fun runner build.
Posted: Tue Oct 01, 2013 12:42 am
by Sixtysixdeuce
I drill and tap the aluminum block first. Then I clamp the material to the aluminum block and drill the holes. I then run the screws thru the holes in the material into the tapped holes in the fixture. This allows me to run the contour with no clamps in the way. Now you all know my secret LOL.
I'm gonna try that next time I'm doing something for which such a procedure would work. Much easier that constantly removing the piece from the vice and trying to get it squared up again and again.
Re: My old is new / fun runner build.
Posted: Tue Oct 01, 2013 8:53 am
by REMJ666
Re: My old is new / fun runner build.
Posted: Thu Oct 17, 2013 5:31 pm
by NCOHOG
If you like that side you should see the other.
Re: My old is new / fun runner build.
Posted: Thu Oct 17, 2013 6:58 pm
by janaya
Sweet ride, I love the milled motor plate. Is there anyone on the forum that mills motor plates on the side for other members?
Re: My old is new / fun runner build.
Posted: Thu Oct 17, 2013 7:50 pm
by NCOHOG
I did mine and a few others. Private message me and maybe we can work something out.
Re: My old is new / fun runner build.
Posted: Thu Oct 17, 2013 9:17 pm
by popboy905
Can u show a pic of the rear hub set up with the wheel off
Re: My old is new / fun runner build.
Posted: Sat Oct 19, 2013 5:41 pm
by NCOHOG
Here you go.
