Page 2 of 2
Re: Making a universal "T" body
Posted: Wed Jan 30, 2013 12:01 am
by slotcarrod
That is a different type of release though!
Nice work on the molds BTW!
Re: Making a universal "T" body
Posted: Wed Jan 30, 2013 1:17 pm
by THEYTOOKMYTHUMB
Charlie don't surf wrote:One guy on this forum (mtookmythumbs) uses the same thing as a release agent too-
I actually use a combination of baby oil and flame retardant. That way friction isn't an issue. Anytime I build a kit I'm out of diff lube before I get to that step...
Sorry Tommy!
Keep us posted!
Re: Making a universal "T" body
Posted: Wed Jan 30, 2013 5:57 pm
by tommykart
Well the prognosis is bleak, going to take a moment to regroup. I can't seem to keep the polycarb hot enough and the vacuum to suck hard enough to make it work. If it sags too much i get a body with wrinkles, but it still doesn't pull it tight enough to the body at the bottom. no problems with the mold release.
Thomas A Edison "With each failure, you get one step closer to the solution" or something like that.