RC10Talk - The Net's Largest Vintage R/C Community

rc10johnny wrote:OK!!!! got the disc not too bad buy got stuck flyin the pelican through the maze....took an hour.....finally went back to the controller setup..there is a flight controls that were reversed....then I made it...I do like all the new weapons...JohnnySr

Why does non-inverted even exist anyway? In what real world application does pushing the stick forward make you go up? Nothing I can think of, not aircraft, not construction or farm equipment, heck, not even in the RC realm. Probably another Microsoft "forward thinking" kind of thing.

SFC K wrote:Man Halgar! You start this over here too?! LOL!

Well, at first I was just looking for information, now it's all about the rant!

Halgar wrote:In what real world application does pushing the stick forward make you go up?

You're wrong! I was on a different site just a few minutes ago and I had to push the stick forward to go up... then back, then forward, then back, then forward... well... you kinda get where I'm going with this.

THEYTOOKMYTHUMB wrote:

Halgar wrote:In what real world application does pushing the stick forward make you go up?

You're wrong! I was on a different site just a few minutes ago and I had to push the stick forward to go up... then back, then forward, then back, then forward... well... you kinda get where I'm going with this.

Yeah, I get where you're going, but how do you get there without no thumbs?

Oh, and Reg is gonna need a link to that site you mentioned!

Halgar wrote:Yeah, I get where you're going, but how do you get there without no thumbs?

Llamas. Lots and lots of Llamas.

On a completely unrelated note, I can't get "I've been workin' on the railroad" out of my head.

Wasn't that done by the llamas and the ppapas?

(you may need to be older than 35 to understand that one )

Halgar wrote:Wasn't that done by the llamas and the ppapas?

(you may need to be older than 35 to understand that one )

True, but I left the ppapas far behind after I got out of the pen.
"behind" being the operative word of course...