Page 2 of 2
Re: titanium turnbuckles / tie rods
Posted: Thu Nov 18, 2010 1:41 pm
by kaiser
i'm running rpm arms but they appear to be the same length as stock.
turns out i did ruin a few of the rpm cups, threaded right through them when i was adjusting the rods.
i have a set of white jconcepts on order now.
Re: titanium turnbuckles / tie rods
Posted: Thu Nov 18, 2010 2:20 pm
by justinspeed79
RPM arms make no difference. Are you sure you didn't get the GT2 set? Sounds obvious, but if you just look at the label quickly it would be an easy mistake to make. Maybe they were mis-labeled???
Re: titanium turnbuckles / tie rods
Posted: Thu Nov 18, 2010 3:05 pm
by kaiser
justinspeed79 wrote:RPM arms make no difference. Are you sure you didn't get the GT2 set? Sounds obvious, but if you just look at the label quickly it would be an easy mistake to make. Maybe they were mis-labeled???
i held them up to the stockers and they are the same length.
Re: titanium turnbuckles / tie rods
Posted: Tue Jan 11, 2011 2:58 pm
by Sir
Anyone know if the original one from technacraft can still be had?